1. After the faucet lever of the basin is lifted, the basin cannot hold water

Disadvantage reason: There is no sink seat in the basin

Sealing strategy: Input putty or silicone at the bottom of the bottom ring

2. The lifting rod of the base faucet slides down after being lifted

Disadvantage reason: Insufficient installation of pull rod connecting rod washers or loose nuts

Countermeasure: Install the lifting rod connecting rod washer or tight the nut

3. The water outlet of the electric faucet is not forked properly or the water volume is reduced

Disadvantage reason: The filter screen of the corrector is closed with dirt or debris

Countermeasure: Put down the corrector bubble and clean the filter screen

4. Simultaneous discharge of bathtub and shower

Disadvantage reason: The valve body is installed in the wrong direction or there are improvements in the water noise

Blocking measures: Remove the water noise, remove debris or break the wall before construction

5. The water output of the shower is small, and the water output is forked or uneven

Disadvantage reasons: low water pressure or debris inside the shower head

Blocking measures: Unscrew the shower and remove the energy-saving rubber or O-ring from the shower inlet, or clean the shower head

6. The basin faucet and cabinet faucet have low water output and no bubbles

Disadvantage reason: low water pressure

Countermeasure: Unscrew the faucet and replace it with a bubble

7. Mandrel leakage

Disadvantage reason: Mandrel waterstop or waterstop ring

Damage counter measure: Replace the waterstop or sealing ring, and add a filter screen at the inlet of the faucet in areas with poor water quality

8. There is noise in the body or piping when turning off the faucet

Disadvantage reasons:

(1) Countermeasures for high water pressure: Reduce the water supply pressure (turn down the triangular valve or water stop elbow); (2) Countermeasures for rapid closure: prevent rapid closure of the faucet;

(3) Poor fixation of piping

Countermeasure: Construction from scratch

9. Water leakage at the connection between the host and the faucet

Disadvantage reasons: Improper device, rubber ring.

Deformation counter measure: Replace the rubber ring and install from scratch

Article source: Guangdong stainless steel faucet http://www.kpjieyuan.com/